







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Techo-Bloc Driveway & Pavers: The Fresno Owner’s Guide
If you’re searching for Techo-Bloc driveway and paver parts in Fresno, you’re likely looking at a sunken section, a shifting edge, or pavers that have loosened up after a few Central Valley summers. We stock and install Techo-Bloc-compatible driveway pavers and replacement units in Fresno, with most paver driveway repairs running between $900 and $4,500 depending on the square footage and what’s happening underneath. The job usually takes one to two days on site, and we carry the common Techo-Bloc paver sizes on the truck for same-week teardown and reset work. What you’re seeing above ground almost always traces back to what’s happening below the pavers, and that’s where a Fresno repair either holds for a decade or fails again in two years.

Which Techo-Bloc Models This Applies To
Techo-Bloc manufactures pavers in several lines, and Fresno driveways typically use the Blu 60, Blu 80, Victorien, Travertina, and Hexa series. The compatibility gotcha most homeowners hit: Techo-Bloc paver thickness varies by line, usually between 60mm and 80mm, and you cannot swap an 80mm unit into a 60mm bed without redoing the base. Check the paver sidewall or underside for a raised product code (starting with “B60” or “B80” on Blu series). We match OEM Techo-Bloc units whenever the existing paver line is still in production. When a Fresno homeowner has a discontinued color or series, we source from Techo-Bloc’s current catalog and cut to match the existing soldier course. Bradford Remodeling Co Fresno is an independent contractor, not affiliated with Techo-Bloc, so our recommendation on OEM versus aftermarket comes down to one thing: whether the replacement needs to match the existing field or whether you’re redoing the entire surface.
Styles & brands we work with







Signs Your Techo-Bloc Driveway & Pavers Is Failing
- Sunken depressions where tires sit. Fresno’s clay soil expands and contracts through wet and dry cycles, and it undermines the base layer. You’re seeing a drainage or base-compaction failure, not a paver failure.
- Pavers rocking or shifting when you step on them. The sand joints have eroded or the edge restraint has let go, usually along the garage apron or the street line. Water gets in, and every car pass works the units loose.
- Moss or weeds sprouting between joints. This tells you the joint sand has washed out or was never properly compacted. The pavers are grinding against each other, chipping the edges with every expansion and contraction cycle.
- Cracks running through individual pavers. A cracked Techo-Bloc unit usually means point load from a heavy vehicle on a void underneath. Pulling the cracked paver without fixing the void just cracks the next one.
- Standing water after rain. Fresno doesn’t get much rain, but when it comes, a paver driveway that holds puddles is pitched wrong or the base has settled unevenly. Water sitting against the home’s foundation becomes a slab and stucco problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest Fresno pricing. A targeted paver repair, where we pull a sunken section, re-grade and re-compact the base, reset the same Techo-Bloc pavers, and re-sand the joints, runs $900 to $2,800 depending on square footage and how much base material has to be hauled out and replaced. A full paver driveway installation runs $7,000 to $18,000 in the Fresno market per our published range. What drives the spread: the paver line you choose (Blu 80 runs higher than Blu 60), the depth of the excavation and base, whether we’re adding a new edge restraint or reusing the existing one, and whether drainage corrections are needed. Your written price includes labor, materials, haul-away, and the joint sand, and it’s the number you pay. The estimate says what we build, and we build what the estimate says.
DIY or Call Us?
Pavers are one of the safer driveway materials to work with, so there’s real room for a homeowner to reset a loose edge paver or re-sand joints. What a homeowner should not attempt is fixing sunken pavers. That requires pulling units, removing contaminated or failed base, re-compacting in lifts, and re-setting the pavers to grade. On a driveway, you’re working against vehicle loads, and a Fresno repair that skips the base work will sink again within a year. If you’re seeing sunken or shifting sections, call us at (559) 785-2712 and we’ll give you a written price before any work starts. No numbers that move at the door.
FAQs

A properly installed Techo-Bloc paver driveway in Fresno should last 25 to 40 years, with the paver units themselves outlasting the base layer and the edge restraint. Re-sanding joints every 3 to 5 years is normal maintenance. Call (559) 785-2712 if you want us to evaluate whether your base is still sound.
Yes, and in most Fresno cases repair is the right call, since the failure usually sits in the base or edge restraint, not in the pavers themselves. We pull the affected area, correct the base, reset the same units, and re-sand the joints. Replacement only makes sense when the paver surface itself is worn through, heavily chipped, or the homeowner wants a different color or series.
Most targeted repairs in Fresno take one day on site, with a second day if we’re reworking the base across a large area or adding drainage. We haul in compacted base material, re-grade, reset the pavers, and compact the joints before we call the job done, and the site is swept clean at close.
We keep the common Techo-Bloc sizes and colors on the truck for typical Fresno repairs, and we order any discontinued or special-order colors directly through Techo-Bloc’s distribution network. We’ll tell you at the estimate which camp your project falls in, so there are no surprises about lead time.
If your Techo-Bloc driveway has a sunken section, a shifting edge, or pavers that have loosened up, call (559) 785-2712 for a free estimate. Curtis Lane will come out, look at what’s underneath the surface, and put a written number in your hand before any work starts. Every job is backed by the 365-Day Done Right Promise in writing.
Written by Curtis Lane, Owner, Bradford Remodeling Co Fresno at Bradford Remodeling Co Fresno, serving Fresno and nearby areas.


