Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Fence Installation: The Fresno Owner’s Guide
ActiveYards fence installation in Fresno typically runs $3,500 to $9,000 for a complete run, depending on linear footage, gate count, and whether we’re setting new posts or working with existing structure. We stock ActiveYards-compatible posts, rails, pickets, and gate hardware on the truck, and most Fresno installs are done in one to two days once materials are confirmed. You’ll usually know something’s wrong when a gate starts dragging, a post leans after a winter storm, or a picket line shows daylight where it shouldn’t. These aren’t cosmetic issues. In Fresno’s hardpan soil and 100-degree summers, a failing fence component keeps failing until it’s replaced with the right spec.
Which ActiveYards Models This Applies To
ActiveYards builds their fence lines around a few core series: the aluminum Carrington, the vinyl Hudson and Lexington, and the Timberwolf wood-composite line. The parts don’t cross between materials. An aluminum Carrington post cap won’t sit on a vinyl Hudson post, and a Timberwolf rail bracket has a different mounting pattern than anything in the vinyl line. The surest way to identify your part is to look for the ActiveYards stamp or label on the inside face of the rail or the bottom of a post cap. If the label’s gone, we measure the picket width, the post profile, and the rail depth right at the truck.
One compatibility gotcha we see often in Fresno: ActiveYards changed the rail depth on some vinyl lines around 2018. A picket ordered off a current catalog may not seat fully into an older rail from the pre-2018 runs. We match part numbers against the original install paperwork when the homeowner has it. When they don’t, we take measurements on site and confirm before anything gets ordered. On OEM versus aftermarket: ActiveYards’ aluminum is powder-coated to a heavier film than most generic stock, so for aluminum runs we recommend OEM or a spec-matched equivalent. For vinyl pickets and bottom rails, quality aftermarket parts are usually indistinguishable once installed and often arrive faster in the Fresno market.
Styles & brands we work with
Signs Your ActiveYards Fence Installation Is Failing
- Gate drags or won’t latch. The hinge posts have shifted out of plumb, usually because the footing wasn’t set deep enough for Fresno’s clay-heavy soil. When the post moves, the gate geometry goes with it.
- Pickets are cracking at the bottom rail. Vinyl expands and contracts significantly in Fresno’s summer heat. If the original install left no expansion clearance, the material binds and stress fractures show up at the smallest cross-section, which is almost always the picket base.
- Posts leaning after a storm. Fresno’s flat terrain means wind loads hit a fence run straight-on. A post that leans after a good blow was either set too shallow or the concrete collar never bonded to the surrounding hardpan.
- Rail joints separating at the bracket. This is usually a bad bracket-to-post connection or a rail cut a quarter-inch short from day one. It gets worse every season as the material cycles through heat and cold.
- White residue or chalkiness on aluminum sections. The powder coat is failing. Once the coating breaks down, the aluminum underneath starts oxidizing. That’s the point where homeowners start seeing surface pitting that no cleaner will restore.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a full ActiveYards fence installation in Fresno, the installed price lands between $3,500 and $9,000. A straight 50-foot vinyl run with one gate usually sits near the lower end. A 150-foot run with two gates, a section of rotten post removal, and hardpan drilling throughout sits near the top. The range moves with three things: linear footage, gate hardware quality, and what we find below grade when we start pulling posts.
Every quote from Bradford Remodeling Co Fresno is a written line item. Parts are listed by part number and count. Labor is a separate line with the hours estimated and the crew size noted. No numbers move at the door. If we find a buried footing that wasn’t disclosed, we document it, write the cost, and get your sign-off before we touch it. The work carries our 365-Day Done Right Promise: if the fence fails inside a year for anything tied to our install, we return and correct it at no charge. In writing, at close, with the scope signed and dated.
DIY or Call Us?
You can safely check the obvious things: run a level against the posts, look for cracks at picket bases, push gently on the gate to see how much play is in the hinges. Those checks tell you what’s wrong. They don’t tell you why it failed. A leaning post usually means a footing problem below the soil line. A dragging gate means hinge load distribution, not just a loose screw. Where DIY goes wrong on ActiveYards installs is almost always the same place: the post layout and depth. Fresno hardpan doesn’t forgive a shallow set, and once concrete is poured around a post in the wrong position, you’re cutting it out and starting over. If the project is more than a single picket replacement, call us at (559) 785-2712 and we’ll put an exact number in front of you before anything gets scheduled.
FAQs
A properly installed ActiveYards vinyl or aluminum fence in Fresno lasts 20 to 30 years. The failure point is almost never the material. It’s the post footing and the original install quality. Vinyl pickets may fade slightly after a decade of Central Valley sun, but structural failure almost always traces back to water intrusion at the post base or an undersized footing in hardpan soil. Call (559) 785-2712 if you’re seeing post lean or rail separation and we’ll tell you whether it’s a repair or a re-set.
Yes, in most cases. A single cracked picket, a loose bracket, or a gate hinge that needs re-shimming is a repair, not a replacement. What can’t be repaired economically is a run where multiple posts have shifted and the rail lines are no longer square. Once the frame’s geometry is gone, you’re chasing one problem after another. We’ll tell you straight which side of that line your fence is on during the estimate.
Most Fresno-area ActiveYards installations run one to two working days once materials are on site. The variables are gate count, existing post removal, and how much drilling the hardpan demands. We’ll give you the day count in writing with the quote.
We stock common post sizes, rail profiles, picket dimensions, and gate hardware for the ActiveYards vinyl and aluminum lines. Less common parts, including curved-top pickets and custom gate widths, are sourced through our supplier network with a lead time we’ll confirm before you approve anything. This part of our work mirrors what we do for other name-brand material lines we work with, including KraftMaid cabinetry, Cambria surfaces, and Silestone, all spec’d and documented so the order is traceable from vendor to your fence line.
Written by Curtis Lane, Owner, Bradford Remodeling Co Fresno at Bradford Remodeling Co Fresno, serving Fresno and nearby areas.
